Week 11 · Metabolic Testing

Resting Metabolic Rate & the Energy Cost of Activity

How many calories does your body burn doing nothing, and how much more does it cost to stand or walk? This week you measure both with indirect calorimetry and test how well prediction equations and published activity values match real people.

Pre-lab ≈ 45 minIn-lab 75 minNotebook ≈ 60 minTools: VO₂-only analyzer or metabolic cart, treadmill

Overview

Total daily energy expenditure (TDEE) has three parts: resting metabolic rate (RMR, about 60–75% for most people), the thermic effect of food (about 10%), and activity (the most variable part). Indirect calorimetry estimates energy use from oxygen uptake: about 4.8–5.0 kcal per litre of O₂, depending on the fuel mix. Part A measures RMR on fasted volunteers; Part B measures the cost of everyday activities so every group collects its own data.

Learning objectives

  1. Describe and apply the standard conditions for an RMR test.
  2. Calculate RMR with the Weir equation, with measured RER (cart) or assumed RER (VO₂-only).
  3. Compare measured RMR with the Harris–Benedict, Mifflin–St Jeor and Cunningham equations.
  4. Measure the oxygen cost of sitting, standing and walking, express it in METs, and compare it with the Compendium of Physical Activities.
  5. Estimate TDEE and explain how measured RMR helps identify low energy availability (RED-S).
Your equipmentHow RMR is calculated
VO₂-only analyzer (e.g., VO2 Master)Weir equation with an assumed RER of 0.85; error is usually within a few percent because VO₂ dominates the equation
Metabolic cart (mask or ventilated hood)Weir equation with measured VCO₂ and RER, which also shows the resting fuel mix
No analyzerUse the RMR and activity backup data sets
ComponentWhat you doTime
Pre-lab readingBackground, interactive tool and one research article≈ 25 min
Pre-lab quiz (5 pts)8-question checkpoint (2 pts) and 3 discussion questions (3 pts)≈ 20 min
Lab activityRMR on 2–3 fasted volunteers, then the energy cost of sitting, standing and three walking conditions for each group75 min
Lab notebook (15 pts)Measured vs predicted RMR, METs and kcal/min for each activity, figures, discussion≈ 60 min

Pre-Lab Reading ≈ 25 min

Every pre-lab has the same three parts: background reading, one article from the research literature, and the pre-lab quiz and discussion questions you submit before lab.

1. Standard conditions for an RMR test

  • Overnight fast of at least 8 hours (water allowed); no caffeine or nicotine that morning.
  • No exercise for at least 12–24 hours; travel to the lab with minimal effort.
  • Rest lying down quietly in a dim, thermoneutral room for 10–20 minutes, then measure for 15–20 minutes, awake and still.
  • Discard the first 5 minutes. Use the most stable period: VO₂ varying by less than about 10% over at least 5 minutes.
RMR (kcal/day) = (3.941·VO₂ + 1.106·VCO₂) × 1440Weir (1949); VO₂ and VCO₂ in L/min
VCO₂ = 0.85 × VO₂When CO₂ is not measured (assumed RER)
Mifflin–St Jeor: 10W + 6.25H − 5A + 5 (♂) or − 161 (♀)W kg, H cm, A y
Cunningham: 500 + 22 × FFM (kg)Uses fat-free mass from Week 3
METs = activity VO₂ (mL·kg⁻¹·min⁻¹) ÷ 3.5Or ÷ your own measured resting VO₂ for a personal MET
kcal/min ≈ METs × 3.5 × kg ÷ 200ACSM conversion

Interactive: RMR equations vs measured

Enter your own height, mass and body fat. Leave VCO₂ blank to see how a VO₂-only analyzer calculates RMR, then add a VCO₂ value to see what a cart adds.

2. Energy availability

When an athlete eats too little for their training, the body conserves energy and RMR falls. A measured RMR well below predicted (a ratio under about 0.90) is one marker used to screen for Relative Energy Deficiency in Sport (RED-S), together with menstrual, bone and performance history.

3. From the literature ≈ 15 min

Read this week

O'Neill, J. E. R., Corish, C. A., & Horner, K. (2023). Accuracy of resting metabolic rate prediction equations in athletes: A systematic review with meta-analysis. Sports Medicine, 53(12), 2373–2398. pmc.ncbi.nlm.nih.gov/articles/PMC10687135/

Today you compare a measured RMR with the Mifflin–St Jeor prediction. This review asks how accurate such equations are in athletes.

Read for:

  1. The abstract, introduction and discussion (skim the meta-analysis statistics).
  2. Why indirect calorimetry is the gold standard, and why prediction equations are still widely used.
  3. Which kinds of equations performed best in athletes.
Optional supplement: GSSI virtual labThe free GSSI University module Resting Metabolic Rate: Measurement and Application for Athletes walks through RMR testing and its use with athletes. Assign it as preparation, as extension work, or as the lab itself if your program has no analyzer.

Before you come to lab

  • RMR volunteers (chosen the week before) follow the standard conditions in section 1 and arrive fasted.
  • Everyone: wear shoes for walking; you will measure the energy cost of five activities.
  • Bring your Week 3 body composition results if you want to use the Cunningham equation.

Pre-Lab Quiz ≈ 20 min

Two parts, both due before lab (5 pts). Checkpoint (2 pts): eight questions on the background and the article; aim for 7 of 8 before you come to lab. Discussion (3 pts): three short written answers you submit to your course site.

Checkpoint

VO₂ = 0.25 L/min and VCO₂ = 0.20 L/min. Weir RMR is about:
(3.941 × 0.25 + 1.106 × 0.20) × 1440 = 1737 kcal/day.
Which condition would invalidate an RMR test?
Exercise raises oxygen uptake for hours afterwards (EPOC).
A 70 kg student walking at 3.0 mph measures 11.2 mL·kg⁻¹·min⁻¹. That is about:
11.2 ÷ 3.5 = 3.2 METs; 3.2 × 3.5 × 70 ÷ 200 = 3.9 kcal/min.
A measured RMR well below predicted in an athlete may suggest:
A measured-to-predicted ratio under about 0.90 is a common screening marker.
According to O'Neill et al. (2023), RMR typically makes up about ___ of total daily energy expenditure in the general population.
That is why an error in RMR has a large effect on estimated energy needs.
O'Neill et al. found that the most accurate equations in athletes were often:
Athletes usually carry more fat-free mass than the people most general equations were built on.
Indirect calorimetry is not used everywhere because it:
Equations are quick and free, which is why their accuracy matters.
A VO₂-only analyzer assumes RER = 0.85. A fasted volunteer's true RER is 0.78. The device will:
Weir kcal per litre of O₂ = 3.941 + 1.106 × RER: 4.88 at 0.85 vs 4.80 at 0.78, about 1.6% higher. The RER assumption matters less than test conditions.

Discussion questions (submit to your course site)

About 75–150 words each unless stated. Each answer is worth 1 point: correct physiology, specific to this lab, and in your own words. Cite the article (author, year) wherever you use it.

1. List three conditions that must be controlled for a valid RMR test, and explain how breaking each would change the result.

2. Calculate a predicted RMR with the Mifflin–St Jeor equation (for yourself or a sample person; your choice) and estimate TDEE with an activity factor you justify.

3. A volunteer's measured RMR is 15% below their Mifflin–St Jeor prediction. Using O'Neill et al. (2023) and this week's reading, give one measurement explanation, one equation explanation and one physiological explanation.

Lab Activity 75 min

Part A — RMR (2–3 fasted volunteers)

Run before or at the very start of lab, by the instructor or a trained team, in a quiet corner or adjoining room: 15 min supine rest, then 15–20 min recording. With one analyzer, measure volunteers back to back before class (for example in an early session), or measure one in class while Part B uses a second device.

Part B — Energy cost of activity (every group)

One participant per group wears the analyzer for 4 minutes each: sitting quietly, standing, walking 2.0 mph, walking 3.0 mph, and walking 3.0 mph at 5% grade (≈ 20 min plus fitting). Groups rotate through the analyzer; groups waiting calculate predictions and process Part A data.

📍 Set up for your campusOne VO₂-only analyzer supports Part B for four groups in about 60 minutes. Part A needs the same device, so schedule RMR volunteers earlier in the day, or use a second analyzer or a cart with a ventilated hood. Without any analyzer, run Part B with HR only and use the backup data.

Timeline

  • BeforeRMR volunteers measured (Part A); files shared with the class.
  • 0:00–0:10Calibration and mask fit; groups enter their participant's mass and predicted RMR.
  • 0:10–1:05Part B rotation: group 1 → 4, about 13 minutes each with changeover. Mark each activity change in the software; record HR in the last 30 s of each 4-minute block.
  • 1:05–1:15Export files; disinfect masks; start calculations.

⬇ Backup RMR data ⬇ Backup activity data

Compendium values listed are approximate reference METs; check the current Compendium of Physical Activities for the exact activity codes you use.

Lab Notebook ≈ 60 min · due at the start of next lab

Step 1 — Calculations ≈ 20 min

  • RMR: mean VO₂ of the most stable 5 minutes after discarding minutes 1–5; =(3.941*VO2+1.106*VCO2)*1440 with L/min (VCO₂ = 0.85 × VO₂ if not measured).
  • Measured ÷ predicted ratio for each equation; % difference.
  • Activities: METs =VO2/3.5; kcal/min =METs*3.5*kg/200; % difference from the Compendium value.

Step 2 — Figures ≈ 15 min

Figure 1: measured vs predicted RMR (clustered columns). Figure 2: measured METs vs Compendium METs for each activity, with the line of identity (y = x).

Step 3 — Discussion ≈ 25 min

  1. How close were the prediction equations to measured RMR? Which was best for each volunteer, and why?
  2. How did the assumed RER (or the measured RER, with a cart) affect the RMR value? What fuel mix does a resting RER suggest?
  3. How did your measured activity METs compare with the Compendium? Why might they differ for a given person?
  4. Using measured or predicted RMR and your activity data, estimate a volunteer's TDEE for a typical day. State your assumptions.
  5. What is RED-S, and how could an RMR test help identify an athlete at risk?

Grading rubric (15 pts)

CriterionPtsFull credit looks like
Calculations5Stable-period RMR, ratios, METs and kcal/min by formula
Figures3Labelled, numbered, line of identity on Figure 2
Discussion6All five answered with data and correct reasoning
Presentation1Clear and complete